LABOR SERVICE FOR MAINTENANCE ACTIVITIES IN THE INSTRUMENTATION AREA
Supply of highly qualified personnel with knowledge in the area of instrumentation and industrial control.
NEVADA 3500 BENTLY SYSTEM
Monitoring of Bently Nevada 3500 System. Visual verification of components (proximitor, extension cable and probe). System verification through linearity curves. Verification of alarm values and event triggering. Rack configuration.
PSV SAFETY VALVE CALIBRATION
Calibration of safety valves with equipment certified by the ENA.
PLC CONFIGURATION
At ERGO INDUSTRIAL we offer the service of programmable logic processor courses or better known as PLC for its acronym in English (programmable logic controller). Today small, medium and large companies seek optimization in their systems to be better, save time and have greater efficiency in their processes, this translates […]
DISTRIBUTED CONTROL UPGRADE FROM MARK VI TO MARK Vle.
Replacement of FIOP S and USC of the MARK Vle distributed control system of turbo compressor, General Electric brand, performing maneuvers and lifting with a 30-ton telescopic crane. Channeling of conduit pipe and installation of supports making connection and labeling of DSC in MARK Vie. Commissioning of the MARK Vle system, performing point tests […]
INSTALLATION OF CONTROL SYSTEMS
This specialty shows ERGO INDUSTRIA in its extensive knowledge in process control automation in the industry where we not only select the best measurement and control equipment but also supply, install and put into service.
MAINTENANCE TO PNEUMATIC / MOTORIZED ACTUATORS
The most common actuator is the manual actuator, that is, a person moves or actuates a device to promote its operation. Over time, it became convenient to automate the actuation of devices, so different devices made their appearance. Currently there are basically two types of linear and rotary actuators. So the idea is […]
VALVE MAINTENANCE
Ergo Industrial has a wide agreement of suppliers of the best brands and of better quality and response time, in addition it has infrastructure and trained personnel with enough experience to carry out the projects in which ball-type valves are involved, butterfly, balloon, gate, governor and PSV.
ASSEMBLY OF TUBING AND INSTRUMENTATION
We have trained personnel for the installation of tubing, either by the punching or SW method, as well as supplies of material such as connectors and needle valves or stainless steel ball, and instrumentation of recognized and reliable brands for the industry.
INSTRUMENTATION MAINTENANCE
In ERGO INDUSTRIAL we have highly trained personnel to carry out I&C activities diagnosing possible potential failures in measurement systems with the following magnitudes: FLOW, TEMPERATURE, PRESSURE and LEVEL and in turn we have standard measurement equipment certified by the EMA , to make a comparison of the […]
English 
Español