MODULAR CHANGE OF HIGH AND LOW PRESSURE TURBINES
Maneuvers and lifting, disassembly of accessories, air intake duct pipes, centrifugal compressor PCL402, BCL 608. Decoupling, verification of distances between TP/colce couplings, taking alignment readings, L/coupling. Replacement of internal parts, radial bearing, tertiary seal, mechanical seal, end seal, shim adjusting washer, L/free. Active axial bearing, inactive axial bearing, […]
GAS TURBINES AND TURBO COMPRESSORS HP AND LP
Inspection: Boroscope of internal parts (axial compressor rotor). Preventive: Replacement of hot parts, liners, 1-stage nozzle, transition piece, clearance verification, alignment (turbine/compressor), maneuvers and lifting. Corrective: Replacement of bearings, air labyrinth seals, oil seals, first stage and second stage nozzle, verification of rotor wire tip clearances […]
PREVENTIVE MAINTENANCE, CORRECTIVE MAINTENANCE, CENTRIFUGAL, RECIPROCATING PUMPS.
Inspection of seals, bearings, oil deflectors, screws and oil pans, impeller wear ring clearances, inspection and replacement of seals and bearings, deflector, impeller, shaft, bronze rings (lubrication) and (alignment) of dynamic team.
ASSEMBLY AND START-UP OF WELDING CELLS
Engineering update and modification of robotic equipment to improve performance. Installation of Force and Control, as well as configuration of PLC'S. Start up.
CORRECTIVE MAINTENANCE
In order to preserve and maintain the equipment in optimal and safe operating conditions, as well as to keep the measurement equipment in good condition, ERGO INDUSTRIAL has certified personnel and equipment to carry out corrective maintenance work in the area of instrumentation and control, improving project delivery times, as well […]
SUPPORT AND CHANNELING OF CONDUIT PIPE AND TRAY INSTALLATION, MAINTENANCE AND REPLACEMENT OF JUNCTION BOXES AND LOAD CENTERS
Installation of supports, channeling, control and power cable laying, boards and load centers; as well as load balancing analysis, hot spot detection, power factor correction.
VERIFICATION AND REPAIR OF GROUND SYSTEMS AND LIGHTNING RODS
In all electrical installations it is necessary to maintain safety conditions and control the accumulation of static charges, as well as prevent the effects of atmospheric discharges, avoiding damage to personnel, equipment and facilities, carrying out preventive and/or corrective maintenance of land records, which consists of the revision of the state of the connections [...]
PREVENTIVE AND CORRECTIVE MAINTENANCE OF THREE-PHASE AND NONO-PHASE MOTORS
Vibration analysis, thermography and insulation resistance tests allow us to make more accurate diagnoses and prevent failures. The poor installation and inadequate maintenance of electric motors present potential dangers, for this reason it is necessary to put into practice all the precautions and measures suitable to prevent these […]
INSULATION RESISTANCE TESTS
Carrying out insulation resistance tests on motors, conductors and transformers to avoid possible failures due to use or overheating.
MAINTENANCE TO CCM's
We carry out predictive, preventive and corrective analyzes through thermography, current measurements, condensation detection, power factor calculation; in order to conserve and maintain the equipment in optimal conditions for its operation, minimize risks by keeping it in safe conditions, ensure the useful life of equipment, keep […]
English 
Español